Kia Forte: Steering wheel / Horn, Heated steering wheel
Horn
To sound the horn, press the horn
symbol on your steering wheel.
Check the horn regularly to be sure it
operates properly.
To sound the horn, press the area
indicated by the horn symbol on your
steering wheel mainly (see illustration).
Heated steering wheel
With the ignition switch in the ON
position, pressing the heated steering
wheel button warms the steering
wheel. The indicator on the button
will illuminate.
To turn the heated steering wheel off,
press the button once again. The
indicator on the button will turn off.
If you turn off the ignition while the
steering wheel heater is ON, the
heater will be OFF.
✽ NOTICE
The heated steering wheel will turn
off automatically approximately 30
minutes after the heated steering
wheel is turned on.
CAUTION
- Do not install any grip to operate
the steering wheel. This
causes damage to the heated
steering wheel system.
- When cleaning the heated
steering wheel, do not use an
organic solvent such as paint
thinner, benzene, alcohol or
gasoline. Doing so may damage
the surface of the steering
wheel.
- If the surface of the steering
wheel is damaged by a sharp
object, damage to the heated
steering wheel components
could occur.
WARNING
If the steering wheel becomes
too warm, turn the system off.
The heated steering wheel may
cause burns even at low temperatures,
especially if used for
long periods of time.
Tilt steering allows you to adjust the
steering wheel before you drive. You
can also raise it to give your legs
more room when you exit and enter
the vehicle.
The steering wheel should be pos ...
Inside rearview mirror
Adjust the rearview mirror so that the
center view through the rear window
is seen. Make this adjustment before
you start driving.
Do not place objects in the rear seat ...
Other information:
Components and components location
Components
[Couple torsion beam axle type]
1. Rear wheel speed sensor connector
2. Rear wheel speed sensor
[Multi link type]
1. Rear wheel speed sensor connector
2. ...
Repair procedures
Removal and Installation
1.
Remove the rear wheel and tire (A).
Tightening torque :
107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)
...