Kia Forte: Manual transmission / Good driving practices
- Never take the vehicle out of gear
and coast down a hill. This is
extremely hazardous. Always leave
the vehicle in gear.
- Don't "ride" the brakes. This can
cause them to overheat and malfunction.
Instead, when you are driving
down a long hill, shift to a lower
gear.When you do this, engine braking
will help slow down the vehicle.
- Slow down before shifting to a
lower gear. This will help avoid
over-revving the engine, which can
cause damage.
- Slow down when you encounter
cross winds. This gives you much
better control of your vehicle.
- Be sure the vehicle is completely
stopped before you attempt to shift
into reverse. The transmission can
be damaged if you do not.
WARNING
Exercise extreme caution when
driving on a slippery surface.
Be especially careful when
braking, accelerating or shifting
gears. On a slippery surface, an
abrupt change in vehicle speed
can cause the drive wheels to
lose traction and the vehicle to
lose control.
WARNING
- Always buckle-up! In a collision,
an unbelted occupant is
significantly more likely to be
seriously injured or killed than
a properly belted occupant.
- Avoid high speeds when cornering
or turning.
- Do not make quick steering
wheel movements, such as
sharp lane changes or fast,
sharp turns.
- The risk of rollover is greatly
increased if you lose control
of your vehicle at highway
speeds.
- Loss of control often occurs if
two or more wheels drop off the
roadway and the driver oversteers
to reenter the roadway.
- In the event your vehicle
leaves the roadway, do not
steer sharply. Instead, slow
down before pulling back into
the travel lanes.
- Never exceed posted speed
limits.
Using the clutch
The clutch should be pressed all the
way to the floor before shifting, then
released slowly. The clutch pedal
should always be fully released while
driving. Do not rest your ...
Dual clutch transmission operation
The dual clutch transmission has 7
forward speeds and one reverse
speed.
The individual speeds are selected
automatically in the D (Drive) position.
WARNI ...
Other information:
Schematic diagrams
Connector and Terminal funciton
Repair procedures
Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
...
Components and components location
Component Location
[4 Door]
1. Rear wheel house trim
[5 Door]
1. Rear wheel house trim
Repair procedures
Replacement
[4 Door]
  ...