Kia Forte: Maintenance / Checking fluid levels
When checking engine oil, engine
coolant, brake fluid, and washer fluid,
always be sure to clean the area
around any filler plug, drain plug, or
dipstick before checking or draining
any lubricant or fluid. This is especially
important in dusty or sandy
areas and when the vehicle is used
on unpaved roads. Cleaning the plug
and dipstick areas will prevent dirt
and grit from entering the engine and
other mechanisms that could be
damaged.
Engine oil and filter
The engine oil and filter should be
changed at the intervals specified in
the maintenance schedule. If the
vehicle is being driven in severe conditions,
more frequent oi ...
Checking the engine oil level
■ Nu 2.0L MPI Engine (Gasoline)
■ Gamma 1.6L T-GDI Engine (Gasoline)
1. Be sure the vehicle is on level
ground.
2. Start the engine and allow it to
reach ...
Other information:
Repair procedures
Inspection
Manual Transaxle Oil Level Check
1.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
2.
Remove the oil filler plug (A).
3.
Check the ...
Components and components location
Components
1. Torsion beam axle
2. Torsion beam
axle cover
Repair procedures
Removal and Installation
1.
Remove the rear wheel and tire (A).
Tightening torque:
...